Beretta 1301 Competition User Manual - Page 31
the same marking is visible on the plates.
View all Beretta 1301 Competition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
• Remove the Beretta Microcore recoil pad from the stock. • Use the 13-mm tube wrench to completely unscrew the retaining nut of the stock and remove the nut, spring washer and plate . • Separate the stock from the receiver and remove the plate . REASSEMBLY • Centre the front spacer on the stock bolt tube. Make sure that the indicator showing the desired drop and cast ("C-60-DX" in the diagram) is visible on the spacer. • Reposition the stock. Place the rear plate inside the stock. Make sure that the same marking is visible on the plates. • Use the 13-mm tube wrench to insert the retaining nut of the stock and spring washer and tighten down with tightening torque 1.6 - 1.8 Kgm (Kilogrammeters). The use of a proper dynamometric wrench is recommended. EN 31