Beretta A300 Outlander Wood Beretta Owner Manual A300 Outlander - Page 33

is designated by the initials SX. The drop and cast of the front spacer and plate must always be synchronised. WARNING: Stock drop and cast modification must be carried out by a competent gunsmith. Failure to comply with these instructions can lead to damage to property or injury to persons. REQUIRED TOOLS N° 1 Philips and 1 flat-head screwdriver. N° 1 Torque wrench T15. N° 1 Hexagonal spanner, 6 mm. N° 1 Tube spanner, 13 mm. N° 1 Torque wrench (previously mentioned) with a 13-mm pipe extension. FIELD STRIPPING • Use the Phillips screwdriver to remove the two screws sunk into the stock. • Remove the Beretta recoil pad from the stock • Use the 13-mm tube spanner to completely unscrew the retaining nut of the stock and remove the nut, spring washer and plate . • Separate the stock from the receiver and remove the plate . REASSEMBLY • Centre the front spacer  on the stock bolt tube. Make sure that the indicator showing the desired drop and cast ("C-60-DX" in the diagram) is visible on the spacer. • Reposition the stock. Place the rear plate  inside the stock. Make sure that the same marking is visible on the plates. • Use the 13-mm tube spanner to insert the retaining nut of the stock and spring washer and tighten down with tightening torque 1.6 - 1.8 Kgm (Kilogrammeters). The use of a proper dynamometric spanner is recommended. • Screw on the recoil pad. EN 31