Binatone Action 950 User Manual - Page 3

the right side of the handset. - pmr

Get Binatone Action 950 PDF manuals and user guides View all Binatone Action 950 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

d. Place the Action 950 units in the charge cradle in an upright position. The Charge LED indicators will light up. e. It takes about 10 hours to fully recharge the batteries if they are completely run down. New batteries take up to 14 hours to fully charge. Important: Always turn off the PMR units when charging. This will shorten the charging time. call Mains socket OR: Charging the batteries (using adaptor) Lift the charge socket cover located on the right side of the handset. Charge jack Insert the round connector of the 9.0V DC/200mA adaptor into the charge jack. Mic/Earpiece jack Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket set to OFF. Use only the mains adaptor provided. Then switch ON the mains socket. %DWWHU\ PHWHU The battery meter is located in the left corner of the LCD Screen. It appears like a battery with three bars inside. These indicate the amount of power available. When the battery level reaches its minimum level in PMR on mode, the unit will emit two beep tones and automatically power off. The Action 950 can detect the battery charge in 4 levels; Battery charge at high level. Battery charge at medium level. Battery charge at low level. At this level, the Action 950 will emit a "beep" sound for every 10 seconds in normal mode. Important: Charge the unit for 10-14 hours. Battery charge at very low level. When the battery level reachs its minimum level in Action 950 on mode, the unit will emit two beep tones and automatically turn off the power . Important: Charge the unit for 10-14 hours. CAUTION : Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. %DWWHU\ OLIH The Action 950 has a built in power saver to make the batteries last longer. But when you are not using the units, turn them OFF to conserve battery power.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
d.
Place the
Action 950
units in the charge cradle in an upright position.
The Charge LED indicators will light up.
completely run down.
New batteries take up to 14 hours to fully
charge.
e.
It takes about 10 hours to fully recharge the batteries if they are
Important:
Always turn off the PMR units
when
charging.
This
will
shorten the charging time.
Mains socket
OR:
Charging the batteries (using adaptor)
Lift the charge socket cover located on
the right side of the handset.
Insert the round connector of
the 9.0V DC/200mA adaptor
into the charge jack.
Plug the mains adaptor into a
240V AC, 50Hz main socket
with the switch on the socket
set to OFF.
Use only
the mains
adaptor provided.
Then switch ON the mains socket.
Mic/Earpiece jack
Charge jack
The battery meter is located in the left corner of the LCD Screen. It
appears like a battery with three bars inside. These indicate the
amount of power available. When the battery level reaches its
minimum level in PMR on mode, the unit will emit two beep tones
and automatically power off.
The
Action 950
can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the
Action 950
will
Important: Charge the unit for 10-14 hours.
Battery charge at very low level. When the battery level
reachs its minimum level in
Action 950
on mode, the unit will
Important: Charge the unit for 10-14 hours.
CAUTION : Risk of explosion if battery is replaced by an
incorrect type. Dispos
e
of used batteries according to the
instructions.
The
Action 950
h
as a built in power saver to make the batteries
emit a “beep” sound for every 10 seconds in normal mode.
emit two beep tones and automatically turn off the
power .
last longer. But when you are not using the units, turn them
OFF to conserve battery power.