Biostar IDEQ 200P iDEQ 200P user's manual. - Page 16

BIOSTAR Motherboard 2.4 Installation and Setup In this section, you will learn how to install the CPU, DDR Module, and also how to set up jumpers and all the information about the components on the motherboard. Not only can you find the installation steps, but also the details and locations of the components on the motherboard. 1. CPU Installation The motherboard supports Intel Pentium 4 processor in the 478 pin package. The motherboard uses a CPU socket called PGA478 for easy CPU installation. When you are installing the CPU, make sure the CPU has a cooling fan attached on the right to prevent overheating. If you do not find the cooling fan, contact your dealer and make sure to install them before turning on the computer. Step1: Pull the lever sideways away from the socket and then raise the lever up to a 90degree angle. Step2: Look for the white dot/cut edge. The white dot/cut edge should point towards the lever pivot. The CPU will fit only in the correct orientation. Step3: Hold the CPU down firmly, and then close the lever. Step4: Put the CPU fan on the CPU and buckle it. Connect the CPU fan power cable to the JCFAN1. This completes the installation. 2 Central Processing Unit: CPU These fan headers support cooling fans built in the computer. Orient the fans to make the heat sink fins to allow air flow to go across the onboard heat sinks instead of the expansion slots. The fan wiring and plug may be different according to the fan manufacturer. Connect the fan fable to the connector while matching the black wire to the ground pin. (1) CPU Fan Header: JCFAN1 Pin 1 1 2 3 Assignment Ground +12V FAN RPM Sense English 16