Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 User Guide - Page 8
Using the 3-in-1 Docking Station
View all Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Using the 3-in-1 Docking Station WARNING To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting. NOTE: The unit will begin to charge once it is docked, assuming the 3-in-1 Docking Station is plugged in. Charging will pause when running the Clean Out Cycle. Once the Clean Out Cycle is complete, charging will resume. 1 2 3 Place unit on 3-in-1 Docking Station. 4 Fill Rinse Cup with water. Pour water into the Rinse Funnel on the 3-in-1 Docking Station to the MAX fill line. 5 6 15s Hold down Clean Out Button on top of the Carry Handle. The cycle only runs when the button is held down. Hold down Clean Out Button for about 10 to 15 seconds to allow unit to flush out and pick up all the water. Repeat as needed. Grasp Brush Roll Window at the front of the window face and pull upward to remove. NOTE: The 3-in-1 Docking Station needs to be plugged into an outlet in order to run the Clean Out Cycle. If the Clean Out Button is held down over a minute, the unit will stop cleaning automatically. 8 www.BISSELL.com