Bissell Pet Hair Eraser® Cyclonic Canister Vacuum 66T6 User's Guide - Page 10

Maintenance and care Cleaning the pre-motor filter The pre-motor filter protects the motor from dirt and dust particles. 1. Turn vacuum OFF ( ). Unplug the vacuum from electrical outlet. 2. Open the dirt cup compartment by lifting up the door latch on the front of the vacuum. Lift out the dirt cup. 3. Remove the filter frame from the filter holder by grasping the lip of the frame and pulling up. NOTICE: This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty. Washable PreMotor Filter 3. 4. Remove the filter from the filter frame and clean by hand washing in warm water. A mild detergent can be used if desired. Allow the filter to air dry thoroughly before replacing. 5. Place the filter back into the filter frame and replace back into the filter holder. NOTE: The filter frame should be placed so the protective frame is visible. 6. Place the dirt cup back into the dirt cup compartment. 7. Close dirt cup compartment door and press down gently until it locks into place. Tip: For maximum cleaning performance, check the filters often and clean or replace if necessary. WARNING: Do not operate cleaner with damp or wet filters or without all filters in place. WARNING: To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. 160 w w w . b i s s e l l . c o m 800.237.7691