Bosch DHR-753-16A200 Product Guide - Page 4
Video, Audio, Monitors, Display Modes, Alarm Handling, Connections, Network, Storage, Exporting
View all Bosch DHR-753-16A200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4 | 700 Series Hybrid/Network Recorder Video Video standard Resolution Compression Inputs Outputs PAL or NTSC auto-detection 704x576 PAL, 704x480 NTSC H.264 8 or 16 composite video 0.5 to 2 Vpp, 75 ohm automatic termination 8 or 16 composite video 1 Vpp, 75 ohm, sync 0.3 V ± 10% Audio Inputs Output Compression Sampling rate 8 or 16 line in (DHR models only), mono RCA, 1 Vpp, 10 kohm 2 line out, dual mono RCA, 1 Vpp, 10 kohm MPEG-1 layer II 48 kHz per channel Monitors MON-A MON-B (Hybrid models only) Live, playback, menus VGA: analog RGB 1280x1024, 60/75 Hz (NTSC/ PAL) CVBS: 1 Vpp, 75 ohm, BNC Y/C Live VGA: analog RGB 1024x768, 60/75 Hz (NTSC/ PAL) CVBS: 1 Vpp, 75 ohm, BNC Y/C Display Modes Monitor A Full, full sequence, quad, multi-screen (live and playback), event call-up (live) Monitor B (Hybrid models only) Full, full sequence, quad, multi-screen, event callup (live) Frame rate PAL/NTSC 25/30 IPS per channel (real time) Multiscreen mode 8 1, 2x2, 3x3 (showing 8 channels) channels Multiscreen mode 16 1, 2x2, 3x3, 4x4 channels Zoom 1.5x, 2x, 3x, 5x Alarm Handling Inputs Outputs Remote notification Malfunction relay Screw terminal, 8 or 16 inputs, configurable NO/ NC, Max. input 40 VDC Screw terminal 4 relay outputs, configurable NO/ NC, max. rated 30 VAC, 40 VDC, 0.5 A, continuous -10 VA Via Control Center software Temperature related failures, Voltage ratings, Disk failures Connections Ethernet 1 or 2 RJ45 modular jack, 8 pins shielded: 10/100/1000 Base-T Biphase Screw terminal connector (5 outputs) Maximum 5 controllable cameras per Biphase output Impedance 128 ohm, max. overvoltage protection ±40 V, max. cable length 1.5 km (0.9 miles) Note: LTC 8785 translator needed for fixed-speed receivers/drivers PTZ control interface RS485 Serial interface RS232 output signals according to EIA/ TIA-232 F, max. input voltage ±25 V 2xDB-9 male connector Intuikey keyboard (KBD Digital or KBD Universal) Conforms to RS485, max. signal voltage ±12 V, power supply to keyboard 11 to 12.6 VDC at max. 400 mA RJ11 modular jack 6 pins USB Five USB 2.0 ports 10/100/1000 Base-T Connect with Bosch iSCSI Video Storage Arrays network interfaces (max 2) Network Bandwidth control Remote users Protocol support IP cameras Supported IP H.264 devices 0.1-100 Mbps limiter Maximum 5 simultaneously connected Control Center users TCP/IP, DHCP, DNS, and SNTP Up to 16 IP H.264 for DHR models (optional) Up to 32 IP H.264 cameras for DNR models (optional) Dinion, FlexiDome, AutoDome Modular, EX series IP cameras, VIP X series encoders (running firmware 3.7 or later, and AutoDome Easy IP Storage Internal HDD Redundancy 500 GB, 1 or 2 TB per disk Up to 4 hard disks RAID-4 (4 hard disks plus optional license required) Effective storage = Smallest disk x 3 Exporting DVD USB Network Built-in DVD+R/RW recorder (optional) Flash memory or external HDD (FAT32) Control Center Software Security Password protection Image authentication Multi-level All recordings and archives in native file format