Bosch SHE3AEE5N Installation Instructions - Page 6
Pre-install Checklist, Electrical Requirements, Cabinet Requirements
View all Bosch SHE3AEE5N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
en-us Before you begin Water inlet hose - minimum 3/8" outer diameter copper tubing or metal braided dishwasher supply line. * Both the elbow and the water inlet hose can be found in the dishwasher supply kit SMZSH1ABUC. Shut-off valve and fittings appropriate for hot water supply line. 2.4 Pre-install Checklist Ensure that the following requirements are met when planning the installation of your appliance. WARNING Avoid Scalding or Electric Shock Hazard ▶ Make sure the water supply and electrical supply are shut off before installation or service. ▶ Do not allow the electrical and supply lines to touch. ¡ Select a location as close to the sink as possible for easy access to water supply and drain lines. ¡ Be sure the unit is installed close enough to the sink so the drain hose length does not exceed 92" (2337 mm) and so that a portion of the drain hose is raised at least 33" above the floor level. ¡ Ensure that the enclosure is square and the opening is at least 34" ( 863.3 mm) high and 24" (609.6 mm) wide. ¡ Check that the opening in the cabinet is large enough for routing the electric cable, water line, and drain hose, and if not, create a new opening. See ¡ If the opening is wood, be sure it is sanded smooth. If it is metal, be sure it is covered by a protective gasket. ¡ Be sure that your water heater set at 120° F (49° C) and the water pressure measures at 15-145 psi (1-10 bar) ¡ Determine the mounting method based on the dishwasher model and counter-top type. See → "Mounting Brackets", Page 9. ¡ Only use the included hardware for the installation. If you are replacing a dishwasher, dispose of old hose and other equipment properly. ¡ To avoid scratching the floor, have floor protection ready for when the dishwasher will be slid into the cabinet. 2.5 Electrical Requirements Ensure that the following electrical requirements are met. Dishwasher electrical rating Volts 120 Hertz 60 Amperes 12 Watts 1,440 (max) Electrical Supply The customer has the responsibility of ensuring that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated 15 or 20 amps. 2.6 Cabinet Requirements Ensure that the cabinet space for the installation meets the required dimensions. If the dishwasher is to be installed in a corner, ensure that there is adequate clearance to open the door as shown. 6