Bosch SHX878ZD5N Use and Care Manual - Page 37

Terminating the wash cycle (Reset) 1. Press and hold Start button P Terminatingthewashcycle for approximately 3 seconds until the display reads ‹:‹,. 2. Wait about 1 minute while the dishwasher drains. 3. Press On/Off button (. You may now power the dishwasher back on and begin a new cycle if desired. Changing the wash cycle When the Start button ( has been pressed, the wash cycle cannot be changed. The only way a wash cycle can be changed is by terminating the wash cycle (Reset). InfoLight® * While the wash cycle is running, a light spot shines on the floor under the appliance door. Do not open the appliance door until the light point is no longer visible on the floor. If the appliance door is not completely closed, the light spot flashes*. If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. In darkened rooms, some light scattering may be visible. This is normal and cannot be changed. You can switch the Infolight on or off. ,:‹‹ Off ,:‹, On To change the setting: 1. Open the door. 2. Press the On/Off button (. 3. Hold down function key # and press Start button P until the display 8 indicates š:‹x (x can be any number). Release both buttons. Operating the Dishwasher en-us 4. Press function key # until the display shows ,:‹,. 5. Press the function key 3 to switch the InfoLight® feature on ,:‹, or off ,:‹‹. 6. Press Start button P to save the setting. * optional feature which may or may not be included with your dishwasher. 37