Bosch WAP24200UC Instructions for Use - Page 13

turned off if the washer is going to be unused for extended periods of time. ▯ Make sure rubber washers are in place at both ends of the water supply hose. Missing washers could cause leaks. ▯ The connection points are under full water pressure. Turn on the water tap and check for leaks. ▯ Periodically inspect the water supply hose and replace with a new hose if cuts, kinks or leaks are observed. LQ Types of drainage hookups Standpipe GUDLQ SLSH FDEOHWLH Water connection hoses ▯ red - Hot water-hose ▯ blue - Cold water-hose Attach the drain hose using the elbow included with your washer. Fit the drain hose to the elbow provided leaving a maximum of 4 inches of drain hose projecting. Insert this section of the drain hose into the drain pipe. Secure the elbow and hose with a nylon tie strap or the equivalent to keep the hose from coming out of the drain pipe during use. Sink siphon Attach this end to water tap. Hand tighten only. Secure the drain hose to the sink siphon using a Ø 0.9 1.6 in. (20-44 mm) hose clip (available from a hardware store). Wash Basin 9 WARNING SCALDING When washing at high temperatures, there is a risk of scalding if you touch hot suds, e.g. when pumping out hot suds into a wash basin. Do not reach into the hot suds. Attach this end of the hose to the back of the washing machine. Hand tighten only. Water drain hose connection NOTICES ▯ Do not reuse an old drain hose. Only use the drain hose and parts included with your washer. ▯ Do not kink or modify the water drain hose. Height of drain point Height difference between the floor and drainage point: max. 39 in. (100 cm). 9 CAUTION APPLIANCE DAMAGE/DAMAGE TO TEXTILES If the end of the drain hose is dipped into the pumped-out water, water can be sucked back into the appliance and can damage the appliance/ textiles. Make sure that: ▯ The sealing plugs do not seal the drain of the wash basin. ▯ The end of the drain hose does not dip into the pumped-out water. ▯ The water flows out fast enough. 13