Bosch WAP24200UC Instructions for Use - Page 21

Default cycle settings At the factory, a temperature range, spin speed range, and cycle duration ("Finish at" time) are pre-set for all cycles. After selection of the cycle, these values are displayed in the display field. You can change the default settings as follows. Changing the temperature range Before and during the cycle, you can change the default temperature range depending on the cycle progress. Press the appropriate button until the desired setting is displayed. The maximum temperature range that can be set depends on the cycle selected. ~ Cycle selection table; Page 19 Changing the spin speed range Before and during the cycle, you can change the spin speed range depending on the cycle progress. Press the appropriate button until the desired setting is displayed. No spin setting: Rinse stop = without final spin, the laundry remains in the last rinse water. The maximum speed range that can be set depends on the cycle selected. ~ Cycle selection table; Page 19 Delay Start When you select a cycle, the duration of the cycle in question is displayed. Before the cycle start, the cycle end ("Finish at" time) can be pre-selected in one-hour steps (h=hour) up to a maximum of 24h. Press the Delay Start button until the desired setting is displayed. NOTICE: The cycle duration is included in the set "Finish at" time. After the start, the pre-selected time, e.g. 8h is displayed and counted down until the wash cycle begins. Then the cycle duration, e.g. 2:40 (hours:minutes) is displayed. Changing the pre-selected time: If the "Delay Start" function has been activated and before the wash cycle has started, you can change the delay time as follows: 1. Press Start/Pause. 2. Press the Delay Start button until the desired number of hours is displayed. 3. Press the Start/Pause button NOTICE: The cycle duration is adjusted automatically when the cycle is running. Changes to the default cycle settings or cycle settings also cause changes in the cycle duration. Additional program settings Extra Rinse Auxillary rinse cycle. Longer cycle duration. For areas with very soft water or for further improvement of rinse results. Easy Iron Special spin cycle with final loosening up of laundry. Delicate final spin - moisture remaining in the laundry is slightly increased. Prewash/Pre Treat For heavily soiled washing. Pour detergent into dispensers I and II. 21