Bosch WAP24202UC Instructions for Use - Page 11
Parts provided with your washer, Set up on a pedestal with drawer, Installation checklist, - reviews
View all Bosch WAP24202UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Parts provided with your washer Back side of the washing mashine # ( Power cord with plug 0 Literature pack; contents: ▯ User manual ▯ Warranty ▯ Covers with hose holders 8 Drain hose @ Elbow to form the hose to fit the drain pipe Washer drum contents 2 water supply hoses are shipped in the washer drum. Be sure to remove each of these items from the drum before using the washer. + 3 H Hot water connection P Cold water connection NOTICE: If any parts are missing please notify your dealer immediately. Set up on a pedestal with drawer Pedestal item number: WMZ 20490 Mount washer on the pedestal according to the instructions in the installation kit. Installation checklist Review the following list and check off each step as it is completed during installation. è Installation Step Page If installing to a pedestal (base), com- 12 plete the base installation before removing the transportation bolts Completely remove all four shipping 12 bolts keeping the bolt and bushing assemblies intact Connect the water supply hose and 12 drain hose Connect the electrical power 14 Slide the washing machine into its final location Level the washing machine (as low as 14 possible) Before washing laundry, run a mainte- 22 nance cycle Importance of installing on a solid, level floor Your new Bosch washing machine utilizes high spin speeds to achieve superior water removal from your laundry resulting in reduced drying time. It is important to install your washing machine on a floor that will provide firm support. This prevents the washer from experiencing excess vibration during spinning that could cause the washer to move or be noisy. The installation surface must be solid and level in both directions. Avoid installing your washer on soft surfaces such as floors with carpet or foam backed covering material. If installing the washer on a wooden floor, observe the following: ▯ install the washer in a corner for better support if possible. ▯ if necessary, reinforce the floor by screwing a water resistant wooden board to the floor (minimum of 1.18 in./30 mm thick). ▯ secure the front feet of the washing machine with holding brackets. A set of holding brackets can be obtained from a specialist store or from Customer Service (part number WMZ 2200). 11