Bosch WAP24202UC Instructions for Use - Page 13
About the AquaShield Hose
View all Bosch WAP24202UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
▯ Make sure the water supply faucet is easily accessible when the washer is in use. The faucet should be turned off if the washer is going to be unused for extended periods of time. ▯ Make sure rubber washers are in place at both ends of the water supply hose. Missing washers could cause leaks. ▯ The connection points are under full water pressure. Turn on the water tap and check for leaks. ▯ Periodically inspect the water supply hose and replace with a new hose if cuts, kinks or leaks are observed. About the AquaShield Hose The AquaShield hose prevents potential flooding in the event the hose develops an internal leak. If the hose leaks, the indicator turns red and water flow is blocked. Water connection hoses ▯ red - Hot water-hose ▯ blue - Cold water-hose Water drain hose connection NOTICES ▯ Do not reuse an old drain hose. Only use the drain hose and parts included with your washer. ▯ Do not kink or modify the water drain hose. Height of drain point Height difference between the floor and drainage point: max. 39 in. (100 cm). Types of drainage hookups Standpipe PD[ PD[ Attach this end to water tap. Hand tighten only. Attach this end of the hose to the back of the washing machine. Hand tighten only. LQ GUDLQ SLSH FDEOHWLH Attach the drain hose using the elbow included with your washer. Fit the drain hose to the elbow provided leaving a maximum of 4 inches of drain hose projecting. Insert this section of the drain hose into the drain pipe. Secure the elbow and hose with a nylon tie strap or the equivalent to keep the hose from coming out of the drain pipe during use. Sink siphon Secure the drain hose to the sink siphon using a Ø 0.9 1.6 in. (20-44 mm) hose clip (available from a hardware store). 13