Bosch WAT28401UC Instructions for Use - Page 21
Starting the cycle, Child lock, Selecting a different cycle, Pausing/Adding a garment to the cycle,
View all Bosch WAT28401UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
1. Open the detergent dispenser tray. 2. Add detergent or additive. 3. Avoid overfilling the compartment to prevent early dispensing. 4. Close the detergent dispenser tray completely before starting the wash cycle. Tip: DO NOT operate the washer without the detergent compartment in place and fully closed. Liquid detergent insert To measure liquid detergent: 1. Pull out the detergent dispenser tray. Press down on the insert and remove the drawer completely. 2. Push the liquid detergent insert forward and down as shown. 3. Reinsert the tray into its compartment. NOTICE: Do not use the liquid detergent insert with geltype detergents and powdered detergents or for cycles with pre-wash and selected "Finish in" time. Starting the cycle Touch the Start/Pause button. Indicator lamp lights up and the cycle starts. NOTICE: If you want to protect the cycle against inadvertent adjustment, select the child lock. ~ Child lock; Page 21 During the cycle, the display field indicates the "Finish at" time and, after starting the washing cycle, the cycle duration and the symbols for the cycle progress. Child lock You can secure the washer against inadvertent changing of the set functions. To do this, activate the child lock after cycle start. To Activate/Deactivate, touch and hold Temperature and Finish in buttons for approximately 3 seconds. The D symbol appears in the display. ▯ D lit steady: The child lock is active. ▯ D blinking: The child lock is active and the cycle selector has been adjusted. To prevent a cycle interruption, set the cycle selector back to the initial cycle. The symbol lights up again. NOTICE: The child lock can remain activated until the next cycle start even after switching the machine off. Then you must deactivate the child lock before cycle start and if necessary activate it again after cycle start. Selecting a different cycle If you have inadvertently started the wrong cycle, you can change this as follows: 1. Touch Start/Pause. 2. Select another cycle. 3. Touch Start/Pause. The new cycle starts from the beginning. Pausing/Adding a garment to the cycle Pausing the wash cycle can be useful for several purposes. e.g. for soaking ~ Soaking; Page 26 Touch Start/Pause. A appears on the display. Wash load will soak in water until continued by touching Start/ Pause. For adding a garment after the cycle begins. 1. Touch Start/Pause. 2. Open door carefully and add or remove laundry item. Note: You can do this as long as the Start/Pause indicator flashes and it is safe to do so. 3. Close door. 4. Touch Start/Pause. The cycle continues. NOTICE: If the cycle is paused but the door will not unlock it could be for safety reasons (high water level, water temperature or drum speed). Cancel cycle For cycles with a high temperature: 1. Touch Start/Pause. 2. Cool the laundry off: Select Rinse. 3. Touch Start/Pause. For cycles with a low temperature: 1. Touch Start/Pause. 2. Select Drain. 3. Touch Start/Pause. Cycle end End appears in the display field and the Start/Pause button indicator lamp is off. If this symbol Åappears in the display, the washer has detected too much foam and it automatically adds an additional rinse to remove the foam. NOTICE: Use less detergent the next time you run the washer with the same load. 21