Bosch WAT28401UC Instructions for Use - Page 27
Default Program and Option settings, Additional Program Option settings
View all Bosch WAT28401UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Default Program and Option settings At the factory, temperature and spin speed options, and cycle duration ("Finish in" time) are pre-set for all cycles. After selection of the cycle, these values are displayed in the display field. You can change the default settings as follows. Changing the temperature range Before and during the cycle, you can change the default temperature range depending on the cycle progress. Press the appropriate button until the desired setting is displayed. The maximum temperature range that can be set depends on the cycle selected. No Spin: This option eliminates the final spin and the load remains saturated with the final rinse water. The pump is activated to remove all residual water. ~ Program selection table; Page 25 Finish in The program end (Finished in) time can be set in one hour increments to a maximum of 24 h (hours). After selecting the desired washing program (at the dial) but before touching the Start button, touch the Finish in button until the desired time is displayed, e.g. 8 h, then touch the Start button to start the washer. NOTICE: The cycle duration is included in the set Finish in time. Changing the spin speed range Before and during the cycle, you can change the spin speed range depending on the cycle progress. Touch the appropriate button until the desired setting is displayed. Here is an example of a 2hr:30min cycle time and an 8 h Finish in time. 8 h is displayed (until the Energy-Saving mode activates) and counts down (approximately 5hr:30min) until the washing cycle begins (at 2hr:30min) then the cycle duration 2:30 is displayed and began. Total time approximately 8 hours. Additional Program Option settings Extra Rinse +1, +2 This feature is helpful for locations with very soft water or to generally improve rinsing results. It allows up to 2 additional rinse cycles to be added to selected programs and will increase program time. Prewash PW For heavily soiled washing. Pour 1/3 of normal detergent amount into pre-wash chamber I and remaining 2/3 into main wash chamber II. SpeedPerfect G For washing in a shorter time with a washing result comparable to that of the standard program. Note: Do not exceed the maximum load. ~ Program selection table; Page 25 27