Bosch WAW285H1UC Use and Care Manual - Page 19

Remove the transport bolt hole covers 1. Remove all four transport bolt hole covers. 2. Pull the tip of the arrow on the cover out slightly to disengage the locking tab. 3. Rotate the cover counterclockwise to remove. Repeat for all 4 transport bolt hole covers. Insert the transport bolt assemblies 1. Each assembly consists of a plastic bushing and a bolt that extends through the bushings. Unscrew the bolt until the threaded end is flush with the end of the plastic bushing. 2. Insert the transport bolt and bushing assembly as shown. The metal housing slides around the bolt through the slot in the plastic bushing as the bushing is slid into place. The open part of the bushing slot should be facing the direction shown to allow the assembly to slide fully into place. 3. When the bolt is in place screw it in until the bolt threads engage the drum. Double check and ensure bolts are screwed into threaded holes and not into cracks or crevices. Repeat the process for all 4 transport bolt assemblies before tightening any all the way. Complete tightening all 4 bolt assemblies until they are each snug in place. 9 CAUTION RISK OF APPLIANCE OR MATERIAL DAMAGE ▯ Despite draining, there will always be some residual water in the appliance. This residual water may leak out and cause damage; therefore, the appliance should always be transported upright. ▯ Ensure transport bolts are removed after transporting washer and before first use. 19