Bose 301 Sonata Owner's guide - Page 6
Setting, connections, speakers
View all Bose 301 Sonata manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
(40heck the connections k to be sure all connections are made positive to positive (+ to +) and negative to tive (- to -) (Figure 4). Make sure that no loose strands of wire touch across terminals. Bridged wires can short circuit and damage the speaker components. Tighten any loose connections before you plug in the receiver or amplifier and turn it on. Setting Up Back cf right speaker Back of left speaker Figure 4 Completed connections Receiver of amplifier Test the speakers To make sure your speakers operate correctly: 1. Place the speakers less than 6 inches (15 cm) apart, facing each other. 2. Turn on your receiver or amplifier, and set it to MONO (monophonic), if that is an option on your model. 3. Set the balance control to normal (center position). 4. Play some deep bass passages of music through the speaker. The sound should seem to come from a point between the two speakers. The bass should be full and natural. If it is not, one of the connections may be reversed, causing the speakers to play out of phase (refer to "Make the connections" on page 6). To correct the problem, make sure all the wires are connected positive to positive (+ to +) and negative to negative (- to Then repeat steps 1 through 4 to re-test the speakers. 7