Bose Model 301 Owner's guide - Page 7
rather than
View all Bose Model 301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
• • S 4. If possible, locate the speaker 112/ to 3 feet from the side wall or openings into•adjacent rooms (Diagram 2, page 6). 5. Allow at least 112/ feet of space on the side of the speaker where the Direct Energy Control and tweeter are located. This will provide for the best dispersion of high frequencies into the room. 6. The most accurate bass will be obtained with the back of the speaker against a wall or moved out up to 2 feet. Further spacing from the wall will result in some reduction in middle bass response. This effect happens with all loudspeakers. VERTICAL PLACEMENT Should you desire to position the speakers vertically, the above guidelines should be followed, with the exception that No. 5 will apply to the areas above each speaker rather than to areas on the side. Be sure to place the speakers so that the tweeter is on top. As with all small speakers, placement directly on the floor will accentuate bass and restrict distribution of high frequencies. Note that for vertical placement, the nameplate can be rotated and moved. Carefully remove the foam piece containing the nameplate. Squeeze the small tab retaining the nameplate. Reposition the nameplate and replace the tab. OUADRIPHONIC OPERATION All of the above considerations are valid when operating the BOSE Model 301 speaker system in quadriphonic or four-channel sound reproduction. Because of the flexibility the BOSE Model 301 speaker system provides in room placement, the operation of the speaker system in four-channel modes is optimum for more listening environments than that of conventional loudspeakers. This is due to the fact that the amount of direct•energy reaching the listening area can be specifically adjusted at each speaker. Diagram 4 indicates the placement position of the BOSE Model 301 in quadriphonic and stereo operation. If your listening environment does not allow the possibility of placing speakers behind you, the Model 301 speakers can be placed as shown along the side walls of the listening area with the Direct Energy Control set for minimum direct energy (see section on adjustment of the Direct Energy Control). PART 1 FRONT SPEAKERS PART 2 r PART 1 ALTERNATE PLACEMENT OF REAR SPEAKERS (SET DIRECT ENERGY CONTROL TO POSITION 4 OR 5) r 1 PART 2 I" DIAGRAM 4 OUADRIPHONIC PLACEMENT CONVENTIONAL PLACEMENT OF REAR SPEAKERS PART 2 PART 1 7