Bose SoundLink Around-ear Bluetooth Owner's guide - Page 2

Safety Information Please read this owner's guide Please take the time to follow the instructions in this owner's guide carefully. It will help you set up and operate your system properly and enjoy its advanced features. Please save this guide for future reference. WARNING: • Contains small parts which may be a choking hazard. Not suitable for children under age 3. • This product contains magnets which can be harmful to pacemaker wearers. • To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. • Do not expose this apparatus to dripping or splashing, and do not place objects filled with liquids, such as vases, on or near the apparatus. As with any electronic products, use care not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard. • D o not place any naked flame sources, such as lighted candles, on or near the apparatus. • Use caution when using your headset/headphones while operating a vehicle or engaging in any activity that requires your full attention. Check and follow local laws regarding mobile phone and headphone/headset use. Some jurisdictions impose specific limitations, such as single earpiece configuration, on the use of such products while driving. • Sounds that you rely on as reminders or warnings may have an unfamiliar character when using headphones. Be aware of how these sounds may vary in character so you can recognize them as needed. • DO NOT use mobile phone adapters to connect headphones to airplane seat jacks as this could result in personal injury such as burns or property damage due to overheating. Remove and disconnect immediately if you experience warming sensation or loss of audio. • Except in case of emergency, Bose recommends that you NOT use these headphones as aviation communication headsets because: --No incoming audio will be heard with a discharged or improperly installed battery. This could result in the potential of missed communications while piloting an aircraft. --Extremely loud ambient noise levels common to many propeller-driven aircraft may impair your ability to receive incoming audio communications, particularly during takeoff and climb out. --The Bose® AE2w Bluetooth® headphones are not engineered for noise conditions, altitude, temperature or other environmental conditions common in non-commercial aircraft, resulting in possible interference to critical communications. • Do not submerge or expose for extended period to water or wear while participating in water sports, i.e. swimming, waterskiing, surfing, etc. • Do not leave a battery on prolonged charge when not in use.  CAUTION: • Refer to the owners guide for safety related information. • Make no modifications to the system or accessories. Unauthorized alterations may compromise safety, regulatory compliance, and system performance. • Long-term exposure to loud music may cause hearing damage. It is best to avoid extreme volume when using headphones, especially for extended periods. • Use only with an agency approved power supply meeting local regulatory requirements (ex. UL, CSA, VDE, CCC). • Refer to the power supply owner's guide for safety related information. • Do not use headphones when operating a motor vehicle or anywhere the inability to hear outside sounds may present a danger to you or others. • Do not drop, sit on or allow the headphones to be immersed in water. • Be sure the earcup ports are kept clear, and that no moisture is allowed to get inside the earcup. • The Bose AE2w Bluetooth headphones do not require scheduled cleaning. Should cleaning be necessary, simply wipe the outside surfaces with a soft cloth. Bose Corporation hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC and all other applicable EU directive requirements. The complete declaration of conformity can be found at: www.Bose.com/compliance. Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Only use attachments/accessories specified by the manufacturer. This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general population. It must not be co-located or be operating in conjunction with any other antenna or transmitter. In the United States: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate this equipment. In USA and Canada: This device complies with part 15 of the FCC rules and Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This class B digital apparatus complies with CAN ICES-3 B / NMB-3 B. Output power less than 6.3mW (8 dBm). Other agency markings FCC ID: A94BA1 IC: 3232A-BA1 Engineered in the United States Made in China Meets IDA Requirements Bose® AE2w Bluetooth headphones Model BA1 XX Names and Contents of Toxic or Hazardous Substances or Elements Toxic or Hazardous Substances and Elements Hexavalent Part Name Lead (Pb) Mercury (Hg) Cadmium (Cd) (CR(VI)) Polybrominated Polybrominated Biphenyl (PBB) diphenylether (PBDE) Metal parts X 0 0 0 0 0 Plastic 0 0 0 0 0 0 parts Speakers X 0 0 0 0 0 Cables X 0 0 0 0 0 O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is below the limit requirement in SJ/T 11363-2006. X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used for this part is above the limit requirement in SJ/T 11363-2006. ©2013 Bose Corporation. No part of this work may be reproduced, modified, distributed, or otherwise used without written permission. 2 - English