Bowflex Ultimate 2 Accessory Pack Assembly Manual - Page 6
Bowflex Ultimate 2 Accessory Pack Manual
View all Bowflex Ultimate 2 Accessory Pack manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
step 3 Parts: • Base Plate (#11) • Curl Mount (#6) � �� Hardware Qty • 7/8" Bolts (#12) 2 • Washers (#15) 2 Tools: • Allen wrench (7/32") 3-1 Attach the Preacher Curl Mount (#6) to the Base Plate (#11) using the hardware as shown in Figure 3. The Curl Mount should lean toward the U-shaped bars on the Base Plate. Tighten hardware completely. Figure 3 step 4 Parts: • Base Plate assembly from Step 3 • Base assembly from Step 2 � Hardware Qty • 2 3/4" Bolts (#13) 4 • Washers (#15) 8 • Nuts (#14) 4 �� Tools: • Allen wrench (7/32") • Wrench/Socket (9/16") or Open End Wrench 4-1 Place the Base Plate (#11) on the lower Side Tubes (#9), narrow edge toward the Tube uprights and the curved edges outside the Side Tubes. Align bolt holes in the Base Plate and Side Tubes. Install the hardware in the two bolt holes closer to the uprights. See Figure 4. Figure 4 4-2 At the bolt holes farther from the Side Tube uprights, insert a 2 3/4" Bolt (#13) through a Washer (#15) into each bolt hole. 4-3 Carefully tilt the base assembly forward to rest on the four Side Tube ends. Install a Washer (#19) and Nut (#18) onto each of the Bolts from Step 3-2. Note: Do not tighten hardware at this time. 4-4 Turn the base assembly upright to rest on all four feet. 6