Brother International BA-10 Network Users Manual - English - Page 6

Button feeder * Tilt the sewing machine. a bo un %1- 19)  rill c) 0 1/1, 1 c* o - --g c;) G o A A-P-0 1. Align the corners of the machine bed Q and button feeder base Q (A and B on machine bed Q with a and b, respectively, on feeder base 0), and secure firmly with wacher (I), lock washer 0, and bolt Q. Make sure there is no film left at A on machine bed 0). 2. Slide the sewing machine bed table O and button feeder base Q as necessary to pass Allen bolts Q with lock washers Q and washers o up through the screw holes from the bottom of the table. (Connect ground wire Q.) Now firmly tighten the nuts on the bolts holding the sewing machine bed table in place°. (Refer to Ei on the previous page.) El Cord connections * Connect all wires and connectors as indicated in the figures below. Button feeder connection * Pull on the connector to make sure it will not come disconnected after connecting the pins. Stop sensor Thread wiper solenoid Button feed Crossover-solenoid Stop switch 9P 6P connector (for sewing machine head) Crossover-stitch solenoid White 9P connector (machine head) White Black Black Red Thread wiper White A solenoid Black Red Black 7P 7P control box Button feeder switch Machine stop sensor Black RecIl Brown Blue White Green Yellow - 4 -