Brother International BAS-300G Instruction Manual - English - Page 25
Installing the pneumatic unit (pneumatic work clamp specifications), INSTALLATION
View all Brother International BAS-300G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
3. INSTALLATION 3-13. Installing the pneumatic unit (pneumatic work clamp specifications) Install underneath the work table. (1) Solenoid valve assembly (2) Washers [2 pcs.] (3) Wood screws [2 pcs.] (4) Rubber hose After installing the pneumatic unit, adjust the air pressure. (Refer to "10-16. Adjusting the air pressure".) NOTE: Make sure that the pneumatic unit does not touch the control box or the work table leg. Connect each air tube to the position with the corresponding number. 1904B Cylinder R Cylinder L Upper knob Lower knob Manual button You can use the valve knobs to adjust the lifting and lowering speeds. The valve knobs should be adjusted so that the left and right sides of the work clamp operate at the same speed. • When the upper knob is tightened, the lifting speed becomes slower. When it is loosened, the lifting speed becomes faster. • When the lower knob is tightened, the lowering speed becomes slower. When it is loosened, the lowering speed becomes faster. You can operate the work clamp while the power is turned off by pressing the manual button. 5220Q 1905B BAS-300G, BAS-311G, BAS-326G 16