Brother International BAS-370E Programmer Instruction Manual - English - Page 159
Brother International BAS-370E Manual
View all Brother International BAS-370E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Chapter 3 Programming with Command Function Moving to position 1 1. Press 9 9 9 and press . The work clamp moves from the start point by each stitch. 2. Press when the needle is at 1. The work clamp stops. If the work clamp passes, input a few stitches and press . The needle returns for a few stitches of the input. Moving in parallel 1. Press 7 7 7 and press F . Input the command for parallel movement. 2. Move the work clamp with . Press L when the needle point is at 2 of the pattern. If pattern C is present after pattern B, pattern C is automatically moved in parallel. If this is not preferred, move pattern C in parallel as in steps and . Saving 1. Specify the program number on the operation panel and press the read/write switch for writing into the floppy disk. Ending program 1. Press P . 158 Programmer