Brother International BAS-612 Instruction Manual - English - Page 48
Automatic, Manual, Program, Knife, Change, Cycle, Carriage, Forward, Higher, Pressure, Lower
View all Brother International BAS-612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
KNIFE REPLACEMENT [3] < Center knife replacement > 1. Set MODE selector 0 to MANUAL. 2. Set CARRIAGE FEED switch Q to FORWARD to advance the carriage feed. 3. Set power switch 0 to OFF. 4. Remove screws 0 and remove center knife * Reverse the order above to install. MODE AUTOMATIC • MANUAL • PROGRAM • KNIFE CHANGE & CYCLE PGM. CARRIAGE FEED FORWARD • O 8 mm Higher pressure Lower pressure .0 0 0 (Cautions on installation) • Align center knife 0 with the screw hole in center knife bracket Q and secure with screws 0 . Fit the tip of the center knife 8 mm above the top surface of the needle plate (align the knife tip with the center knife guide bottom). Turn the power switch to ON and make sure that the center knife tip does not protrude from center knife guide Loosen screws 0 and adjust the center knife pressure by center knife bracket 0 Increasing the pressure too much will decrease center knife durability. 1. Set MODE selector 0 to MANUAL. 2. Set CARRIAGE FEED switch 0 to FORWARD to advance the carriage feed. 3. Set power switch 0 to OFF. 4. Remove screws 0 and remove center knife 0 . 5. Remove screws and needle plate Q 6. Remove setscrews Q and fixed knife * Reverse the order above to install. MODE AUTOMATIC MANUAL • PROGRAM • KNIFE CHANGE & CYCLE PGM. CARRIAGE FEED FORWARD -44-