Brother International BE-1201B-AC Machine Settings - English - Page 4

BE-101,916,901,1216,1201AC For Technical Assistance Please Call Toll Free 1-877-4BROTHER Machine Settings Setting of Lock Stitch - Lock stitches are very tiny stitches used to keep the thread from coming out of the garment. Lock stitch ON/OFF at sewing start point - Inserts a lock stitch at the beginning of the design. Default setting is OFF. Recommended setting is ON. Lock stitch ON/OFF at sewing end point - Inserts a lock stitch at the end of the design. Default setting is OFF. Recommended setting is ON. Lock stitch ON/OFF at sewing start point after thread trimming - Inserts a lock stitch at the beginning of sewing after a thread trim. Default setting is OFF. Recommended setting is ON. Setting of Speed Limit in a Small Pitch - Used to automatically slow down the machine on small stitches. Must set a stitch width limit and the sewing speed at which anything under that stitch width will sew. There will be two settings stored in the machine depending on the flat/cap position. You will need to set these up in each different mode. Default setting is OFF. Recommended setting is ON. Flats: 0.8mm at 720spm. Caps: 1.0mm at 620spm. Display of Information - Displays information about the machine and sewing data. Feed timing - Determines when the pantograph starts to move in relation to the position of the needle. Based on material thickness. Default setting is THIN. Recommended setting is THIN. Automatic input setting - used to automatically read designs sequentially and how they are handled. Default setting is MANUAL. Recommended setting is MANUAL. Hoop Retract Point - Used to position the hoop in another place beside the start point. Can be used at the start/end of a design or during the middle of sewing. Automatic hoop retract - Goes to the hoop retract point at the end of sewing Default setting is OFF. Recommended setting is OFF. 4 Revised 1/10/05