Brother International BE-1201B-AC Quick Reference Guide - English - Page 1

BE-101,916,901,1216,1201 Quick Ref. For Technical Assistance Please Call Toll Free 1-877-4BROTHER LOADING A DESIGN FROM A FLOPPY DISK Insert floppy disk into the disk drive Press the "Floppy Disk" button to enter machine memory selection screen . Press the "Floppy Disk" button to enter floppy disk selection screen . Press the "Arrow Keys" to move the highlighted area over the design you wish to load. Press the "Needle Select" buttons to change pages. Press the "Start" button to copy the design to the machine memory and make it the active design. Note: Machine will not start. You would have to press "Start" again before the machine would start sewing. SETTING THE COLOR SEQUENCE Press the "Needle Set" button to enter the color programming mode Use the "Numeric Keypad" to assign a needle number (Color). Use the "Zero" button to assign a two-digit needle. (example: 12) POSITIONING AND SEWING THE DESIGN Press the "Arrow Keys" to center your design in the hoop. Press the "Confirm" button to verify the design will fit in the frame at the location you have chosen. Use the "Numeric Keypad" to assign a sewing speed by pressing a number 1-6. 1=fast, 6=slow. Press the "START" button to begin sewing the design. ENTER A DESIGN FROM THE MACHINE MEMORY Press the "Floppy Disk" button to enter machine memory selection screen . Press the "Arrow Keys" to move the highlighted area over design you wish to load. Press the "Enter" button to select the design for sewing. Set the color sequence for the design. Position and Sew the design ROTATE A DESIGN Press the "Edit" button to enter the design edit mode. Press the "Left & Right Arrow" buttons to change the degree at which to rotate the design. Continue to select needle numbers until all colors have been programmed. Press the "End" button to exit the colorprogramming mode with the sequence saved. Press the "End" button to save the rotation degree and exit the edit mode. 1