Brother International DZ3400 Operation Manual - Page 20
around the spool pin or the machine may
View all Brother International DZ3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
KNOWING YOUR SEWING MACHINE Fully insert the spool of thread for the bobbin c onto the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom. Memo ● When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool. cb Slide the spool cap onto the spool pin. d With the slightly rounded side of the spool cap positioned toward the left, slide the spool cap onto the spool pin as far as possible to the right so that the spool is moved to the right end of the spool pin. a a Spool cap (small) b Spool (cross-wound thread) c Space While holding the spool with your right hand, e and then pass the thread under the thread guide. CAUTION ● If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the machine may be damaged. ● Three spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the machine may be damaged. a Thread guide Pass the thread under the thread guide cover f from the back to the front. Hold the thread with your right hand so that there is no slack in the thread that is pulled out, and then pass the thread under the thread guide cover with your left hand. a Thread guide cover 18