Brother International HL-1260 Service Manual - Page 44
Low-voltage Power Supply Assy
View all Brother International HL-1260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
4. LOW-VOLTAGE POWER SUPPLY ASSY 4.1 Outline The low-voltage power supply assy consists of the low-voltage generating block (hereinafter the DC block) and the heater drive circuit block to turn the heater on (hereinafter the AC block). When the power switch (SW1) is turned on, AC power is supplied to the low-voltage power supply assy. The DC block generates +5 VDC, and +24 VDC. When the heater is turned on, AC power is supplied to the AC block under control of the heater on-off signal from the engine controller. +24V output is reserved in the DC block, for the cooling fan for the low-voltage power supply assy. 4.2 Protection Functions Each of the power supply circuits, +5V, and +24V, has a protection function to prevent the circuit from accident by automatically cutting off the power supply in the case of a over-voltage or overcurrent of the load. When the cooling fan stops to rotating, an over-voltage protection or a short-circuit protection function is activated, and all the DC power supplies are cutoff. In this case check and clear the cause on the load after turning the power switch (SW1) off, and then switch the power on again at least one minute after the power shut-down. III - 12