Brother International HL-720 Quick Setup Guide - English - Page 14

English: HL-YL Quick Setup Guide, Body Additionally, there are four sub-menus as shown in the table below. Select a sub-menu by clicking the desired sub-menu with the mouse, by using the cursor key and the Enter key, or by using the keys shown below to switch the screen to the sub menus. Menu Direct Access Printer Setup Console Config Guide Help Press the keys Functions Alt + D You can directly control printer functions such as Print Form, Self Print, Reset Printer, Sleep Control. Alt + P You can enter the setting mode to change further printer settings, such as, margin settings, continue mode, reprint function, font, and sleep mode. Alt + C You can change the environment settings for the RPC program: color, Status Monitor configuration, etc. Alt + G You can get into the Guide mode. F1 You can get on-line help about the current highlighted item by pressing F1. Using the Printer Status Monitor Program Type C:\RPCX>STMX and press the Enter key to make the Printer Status Monitor Program stay resident in your computer memory. If there are any changes to the printer status, it displays a message on your computer screen. If the printer status monitor program stays resident in your computer, you can monitor the printer status on your computer screen immediately using the hot-key sequence (Ctrl+Alt+R). To remove the Printer Status Monitor program from your computer memory, type C:\RPCX>STMX/R and press the Enter key. t The RPC works in the environment where your printer is directly connected to your computer. If you are using any printer buffer switches which do not support bi-directional communication between the printer and computer, the program works only in the PC to printer direction and cannot receive printer status information. t The program does not work with printers on a network. t If the RPC conflicts with some application software, exit your application software and then run the RPC. t The RPC may work in the DOS-compatible box screen mode of Windows, however, it is recommended that you completely exit from Windows to the DOS prompt before using the RPC. t The Printer Status Monitor and some other Terminate-and-Stay programs cannot coexist in the computer's memory. If they do not work properly together, use them one at a time. You can suspend the Printer Status monitor with any of the following methods or commands. • Type C:\RPCX>STMX/R and press the Enter key. • Hold the space bar down while executing the AUTOEXEC.BAT file at DOS startup to prevent the status monitor being loaded as a TSR program. 13