Brother International HS-2500 Users Manual - English - Page 41
Starting to sew
View all Brother International HS-2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Starting to sew Raise the needle by turning the handwheel a toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) While holding the end of the thread and the d fabric with your left hand, turn the handwheel toward you (counterclockwise) with your right hand to lower the needle to the starting point of the stitching. 2 or a Mark b Needle position button Raise the presser foot lever. b a Presser foot lever Place the fabric under the presser foot, pass c the thread under the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. Lower the presser foot lever. e a Presser foot lever On models equipped with a sewing speed f controller, slide the sewing speed controller to the left or right to adjust the sewing speed. Refer to "Sewing speed controller (for models equipped with the start/stop button)" (page 13). a 5 cm (2 inches) a Sewing speed controller Slowly press down on the foot controller. g (With models equipped with (start/stop button), if the foot controller is not connected, press once.) or aStart/stop button X The machine starts sewing. 39