Brother International Innov-is 6000D Operation Manual - Page 56

LOWER THREADING ■ Untangling Thread from Beneath the Bobbin Winder Seat If the bobbin winding starts when the thread is not passed through the pre-tension disk correctly, the thread may become tangled beneath the bobbin winder seat. Wind off the thread according to the following procedure. d Cut the thread near the bobbin and hold thread end with your left hand. Unwind the the thread counter clockwise near the bobbin winder seat with your right hand as shown below. a Thread b Bobbin winder seat CAUTION • Do not remove the bobbin winder seat even if the thread becomes tangled under the bobbin winder seat. It may result in injuries. a If the thread becomes tangled under the bobbin winder seat, press once to stop the bobbin winding. e Wind the bobbin again. Note • Make sure that the thread passes through the pre-tension disk correctly (page 38). b Cut the tension thread disk. with scissors near the pre- a Pre-tension disk c Push the bobbin winder switch to and then raise the bobbin at least the right, 10 cm (4 inches) from the shaft. 42