Brother International IntelliFax-2920 Users Manual - English - Page 91
Start, Error Messages, Cause, Action - toner cartridge
View all Brother International IntelliFax-2920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Chapter 11 ERROR MESSAGES ERROR MESSAGE CAUSE Machine too Hot The inside of the machine is too hot. No cartridge No Paper Fed The toner cartridge is not installed properly. The machine is out of paper or paper is not properly loaded in the paper tray. No Response/Busy The number you dialed does not answer or is busy. Not Registered You tried to access a One-Touch or Speed Dial number that is not programmed. ACTION Make sure you can hear the fan in the machine spinning and the exhaust outlet isn't blocked by something. If the fan is spinning, remove any obstacles that surround the exhuast outlet, and then leave the machine turned on but do not use it for several minutes. If the fan is not spinning, you need to save the faxes before you follow the suggestions below. (For FAX-2820, FAX-2910 and MFC-7220) When you turn off the machine's power switch its memory will be cleared. To check whether the machine has faxes in its memory see Checking if the machine has faxes in its memory on page 11-6. If there are faxes you need to save them before following the suggestions below (To save the faxes, see Forwarding faxes to another fax machine on page 11-6. For MFC-7220 also see Transferring faxes to your PC (MFC-7220 and MFC-7225N only) on page 11-6). Turn off the machine's power switch and then turn it on again. If the error message continues, leave the machine for several minutes and try it again. (For FAX-2920 and MFC-7225N) Turn off the machine's power switch and then turn it on again. If the error message continues leave the machine for several minutes and then try it again. (The machine can be turned off for up to 4 days without losing faxes stored in the memory.) Reinstall the toner cartridge. Refill the paper in the paper tray and then press Start. -OR- Remove the paper and load it again and then press Start. Verify the number and try again. Set up the One-Touch or Speed Dial number. (See Storing One-Touch numbers on page 5-1 and Storing Speed-Dial numbers on page 5-2.) 11 - 3