Brother International LB-6770THRD Users Manual - English - Page 88
Raise the buttonhole lever to its original
View all Brother International LB-6770THRD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
UTILITY STITCHES Note z Do not lower the needle into fabric when aligning the marks. Desired results may not be achieved. z When lowering the presser foot, do not push in the front of the presser foot. Raise the presser foot lever, remove the fabric, h and then cut the threads. Raise the buttonhole lever to its original i position. Insert a pin along the inside of one bar tack at j the end of the buttonhole stitching to prevent the stitching from being cut. 1 a a Do not reduce the gap. Pull down the buttonhole lever as far as f possible. a Pin Use the seam ripper to cut towards the pin and k open the buttonhole. a a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. a a a Seam ripper For keyhole buttonholes, use the eyelet punch to make a hole in the rounded end of the buttonhole, and then use the seam ripper to cut open the buttonhole. b a Buttonhole lever b Bracket Gently hold the end of the upper thread in g your left hand, and then start sewing. X Once sewing is completed, the machine automatically sews reinforcement stitches, then stops. 86 a a Eyelet punch Note z When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.