Brother International MFC-7750 Users Manual - English - Page 120
Remote Control Commands, MFC and enter your Remote Access Code 159
UPC - 012502563921
View all Brother International MFC-7750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
106 C H A P T E R T W E L V E Remote Control Commands Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (159 ), the system will signal you with two short beeps to enter a remote control command. Remote Control Commands Operation Details 91 Playing voice messages After one long beep, the MFC plays ICM and Memo. 1 (Skip back) 2 (Skip next) 9 STOP Playing 92 Record Memo 93 Erase all ICM & Memo 94 Play and Record OGM in memory 1 Play 1 MSG CTR OGM 2 F/T OGM 2 Record 1 MSG CTR OGM 2 F/T OGM 95 Changing Fax Forwarding/ Paging setting 1 OFF 2 Fax Forwarding 3 Paging 4 FAX FWD NO. Press 1 while listening to an ICM or Memo message to play it again. If you press 1 before a message, you will hear the previous message. While playing ICM and Memo, you can skip to next message. Stop playing the ICM and Memo. After one long beep, you can record a memo. You can stop recording by pressing 9. If you hear one long beep, the erase is accepted. If you hear three short beeps, you cannot erase because all voice messages have not been played, or there is no voice message to erase. *This code erases all recorded messages, not one at a time. The MFC plays the selected OGM. You can stop playing OGMs by pressing 9. After one long beep, you can record the selected OGM. You will hear the message played once. You can stop recording the message by pressing 9. If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met (Example: registering paging number). You can register your fax forwarding number by using 4. FAX FWD NO (See page 108). Once you have registered the number, the MFC will change automatically to "FAXFWD:ON" mode. Then retrieve a Memory Status List by entering 961(See page 107) to make sure that the Fax Forwarding number you registered is correct in the list. 96 Retrieve Fax 1 Memory Status List 2 Retrieve all faxes 3 Erase fax from the memory 97 Check the receiving status 1 FAX 2 VOICE 98 Change Answer Mode 1 MSG CTR 2 FAX/TEL 3 FAX 90 Exit Enter the number of the remote fax machine to receive a report or stored fax message. If you hear one long beep, you can erase the fax message from the memory. You can check whether your MFC has received any FAX or VOICE messages. If yes, you will hear one long beep. If no, you will hear three short beeps. If you hear one long beep, you can change the answer mode. If you hear three short beeps, you cannot change it. (Example: When there is no MSG CTR OGM and you tried to change to MSG CTR mode.) After a long beep, you can exit remote control.