Brother International MFC-J5910DW Quick Setup Guide - English - Page 33

For Wireless Network Users 19 One-push configuration using WPS or AOSS™ (Windows® and Macintosh) a Confirm your wireless access point/router has the WPS or AOSS™ symbol as shown below. b Place the Brother machine within range of your WPS or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your access point/router. c On your machine, press Menu. Press s or t to display Network, and then press Network. Press WLAN. Press s or t to display WPS/AOSS, and then press WPS/AOSS. When Network I/F switched to Wireless. is displayed, press Yes to accept. This will start the wireless setup wizard. To cancel, press No. Note If your wireless access point/router supports WPS (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Configuration using the PIN Method of Wi-Fi Protected Setup in the Network User's Guide. d When the LCD shows Start WPS or AOSS, press the WPS or AOSS™ button on your wireless access point/router. See the user's guide of your wireless access point/router for instructions. e A connection result message appears for 60 seconds on the LCD and a WLAN report will automatically be printed. If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 34. Wireless setup is now complete. A four level indicator at the upper left your machine's LCD will show the wireless signal strength of your access point/router. To install MFL-Pro Suite, continue to step 20. For Windows® Users: Now go to Page 36 For Macintosh Users: Now go to Page 39 Wireless Network Then press OK and your machine will now automatically detect which mode (WPS or AOSS™) your wireless access point/router uses and try to connect to your wireless network. 33