Brother International NX-450 Users Manual - English - Page 34
Threading the needle manually, without using the needle threader, Using the twin needle
View all Brother International NX-450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Threading the needle manually (without using the needle threader) Using the twin needle With the twin needle, you can sew two parallel lines When using special thread, thread with a thickness of 130/20 or thicker, the wing needle or the twin needle of the same stitch with two different threads. Both upper threads should have the same thickness and 1 which cannot be used with the needle threader, quality. Be sure to use the twin needle, the extra thread the needle as described below. spool pin and the spool cap. For details on the stitches that can be sewn with the Thread the machine to the needle bar thread a guide. twin needle, refer to "Stitch Settings" (page 134). • For details, refer to "Upper Threading" (page 28). Lower the presser foot lever. b 1 a Pressor foot lever Pass the thread through the eye of the needle c from front to back. Raise the presser foot lever, pass the end of the d thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. CAUTION ● Only use the twin needle (part code: X59296-151). Use of any other needle may bend the needle or damage the machine. ● Never use bent needles. Bent needles can easily break, possibly resulting in injuries. Install the twin needle. a • For details on installing a needle, refer to "Replacing the needle" (page 39). Thread the upper thread for the left needle b eye. • For details, refer to steps a through k of "Threading the upper thread" (page 28). Manually thread the left needle with the upper c thread. Pass the thread through the eye of the needle from the front. • The needle threader cannot be used with the twin needle. If the needle threader is used with the twin needle, the sewing machine may be damaged. Upper Threading 33