Brother International PC-210 Users Manual - English - Page 78
wheel toward you to check that the, needle does not touch the presser foot. If
View all Brother International PC-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
UTILITY STITCHES CONTENTS Press the seam allowance so that the right side 4 (the side that will not be stitched) has an extra 3 mm (1/8 inch). 1 2 1 Wrong side of fabric 2 3 mm (1/8 inch) Align the zipper teeth with the pressed edge 5 of the fabric having the extra 3 mm (1/8 inch), and then baste or pin the zipper in place. CAUTION ● When using zipper foot "I", be sure to select the straight stitch (center needle position), and slowly turn the balance wheel toward you to check that the needle does not touch the presser foot. If a different stitch is selected or the needle hits the presser foot, the needle may bend or break. Sew the zipper to the piece of fabric with the 8 extra 3 mm (1/8 inch), starting from the base of the zipper. 2 1 GETTING READY SEWING BASICS UTILITY STITCHES 1 Zipper teeth 2 Basting stitching Attach the presser foot holder to the right pin 6 of zipper foot "I". If the stitching will be sewn on the right side, attach the presser foot holder to the left pin of the zipper foot. 1 I 2 CAUTION ● When sewing, be sure that the needle does not touch the zipper, otherwise the needle may bend or break. When you are about 5 cm (2 inch) from the 9 end of the zipper, stop the sewing machine with the needle lowered (in the fabric), raise the presser foot lever, and then open the zipper and continue sewing. 1 Pin on the right side 2 Needle drop point • For details, refer to "Replacing the presser foot" (page 29). Select stitch . 7 • For details, refer to "Selecting stitching" (page 54). APPENDIX INDEX 72