Brother International PC 420 Users Manual - English - Page 59
Cutting the thread, Do not press the thread cutter button
UPC - 012502541004
View all Brother International PC 420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES Cutting the thread When you have finished sewing, cut the threads. The threads can be cut in either of two ways. ■ Using the thread cutter button When you wish to finish the stitching, press 1 (thread cutter button) once. 1 1 Thread cutter button X The threads are cut and the needle is raised. Raise the presser foot lever. 2 Memo ● The machine can be set so that the threads will be cut when sewing is finished. For details on setting the machine so that the threads are cut automatically, refer to "Automatically cutting the thread" (page 58). ■ Using the manual thread cutter When sewing with thread thicker than #30, nylon or metallic threads, or other special threads, use the thread cutter on the side of the machine to cut the threads. When you wish to finish the stitching and the 1 sewing machine is stopped, press (needle position button) once to raise the needle. 1 1 1 Presser foot lever CAUTION ● Do not press the thread cutter button after the threads have already been cut, otherwise the needle may break, the threads may become tangled or damage to the machine may occur. Note ● Do not press the thread cutter button if there is no fabric under the presser foot or while the machine is sewing, otherwise damage to the machine may occur. 1 Needle position button X The needle is raised. Raise the presser foot lever. 2 1 1 Presser foot lever Pull the fabric to the left side of the machine, 3 and then pass the threads through the thread cutter to cut them. 1 APPENDIX INDEX 1 Thread cutter Sewing 53