Brother International PE-170D Users Manual - English - Page 17
It's a good idea to have several full bobbins on, hand before start your project., START/STOP button - sewing machines
View all Brother International PE-170D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CONTENTS MACHINE KNOWLEDGE EMBROIDERING MAINTENANCE ERROR MESSAGE 2 3 3. Guide the thread through the machine and the bobbin winding guide as marked with the dotted line. 1 4. Guide the thread through the small hole in the side of the bobbin from the inside. Holding the thread end, push the bobbin winder shaft to right. * Match the groove of the bobbin with the spring on the shaft. 1 Spring on the shaft 2 Groove in the bobbin 5. Holding the thread end, press the "START/STOP" button. Wind the thread a few times around the bobbin and press the "START/STOP" button again. Trim the excess thread from the top of the bobbin after the machine stops. * It is important to trim the thread close to the spoolend. 6. Press the "START/STOP" button. The machine will stop automatically when the bobbin is full. Press the "START/STOP" button to stop at any time or when the bobbin has stopped moving and the motor is still running. 1 "START/STOP" button 7. Push the bobbin shaft to the left. Remove the bobbin and continue sewing. 8. Set the bobbin into the shuttle as shown on page 15. It's a good idea to have several full bobbins on hand before start your project. TROUBLESHOOTING PATTERNS EMBROIDERING USING A SMALL FRAME (OPTIONAL) EMBROIDERING USING A EXTRA-SMALL FRAME (OPTIONAL) EMBROIDERING USING A LARGE FRAME (OPTIONAL) 14