Brother International PR-650 Operation Manual - Page 229
Fabric precautions, Preparing to use the cap, frame
View all Brother International PR-650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
■ Cap fabric not recommended for embroidering • Caps with a front panel that is less than 50 mm (2 inches) high (such as a sun visor) • Children's caps • Caps with a brim that is longer than 80 mm (3-1/16 inches) Fabric precautions ■ Cap fabric recommended for embroidering • 35%Cotton / 65%Polyester • 100%Cotton • 80%Wool / 20%Nylon • 15%Wool / 85%Acrylic ■ Cap fabric not recommended for embroidering If caps of the following types of fabric are used, they will be very difficult to frame, easily wrinkled, or easily shrink. • Polyester Foam • Stretch material • Melton Wool • 100%Nylon • Suede 1 Put the two thumb screws back in the embroidery frame holder. Remove the two upper thumb screws of the 2 cap frame driver and set aside. Loosen the two lower thumb screws (4 turns). Preparing to use the cap frame ■ Installing the cap frame driver Touch → → → in order to view a video of the operation on the LCD (refer to page 206). 1 Upper thumb screws 2 Lower thumb screws Pass the machine bed through the ring of the 3 cap frame driver. Remove the embroidery frame holder from the carriage on the machine, and then install the cap frame driver. Before removing the embroidery frame holder, remove the embroidery frame. (Refer to "Removing the embroidery frame" on page 68.) Loosen and then remove the two thumb 1 screws and the embroidery frame holder. 1 Machine bed Note ● Be careful that the cap frame driver does not hit any nearby parts, such as the 7 presser foot. Attach the cap frame driver to the carriage as described below in steps 4 through 7. 1 Thumb screws • The removed thumb screws remain attached to the embroidery frame holder. Using the Optional Cap Frame 227