Brother International PR-650 Installation Guide for KIT CW PRCW1 - Page 26

CASE 2: When PE-DESIGN NEXT is already installed on the computer CASE 2: When PEDESIGN NEXT is already installed on the computer [Step 1] Upgrading PE-DESIGN to the Latest Version Memo • If the "Always check for most recent version at startup" check box is selected, the software is checked at startup to determine whether or not it is the latest version. • If the message shown below appears, the latest version of the software is being used. Note • This feature cannot be used if the computer is not connected to the Internet. • It may not be possible to check for the latest version if a firewall is turned on. Turn off the firewall, and then try performing the operation again. • Administrator privileges are required. • The enclosed CD-ROM2 (for PE-DESIGN) can also be used to install PE-DESIGN NEXT version 9.2. Insert the CD-ROM into the computer's CD-ROM drive, run "setup.exe", and then follow the installer instructions. a Start Layout & Editing. Click 1, then 2 to check for most recent software version. 1 → The "User Account Control" dialog box appears. c Click "Yes". [Step 2] Upgrading the USB Card Writer Module with the Upgrade Wizard 2 → The software determines whether or not it is the latest version. If not, the following message appears. b Click "Yes", and then download the latest version of the software from the Web site. a Connect the USB card writer module to the computer's USB port, and then start Layout & Editing. b Click 1, then 2 to display the "Options" dialog box. 1 2 → The following dialog box appears. 22