Brother International SB530T Operation Manual - Page 31
turn the handwheel toward
View all Brother International SB530T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
■ Attaching the extra spool pin Insert the extra spool pin onto the end of the bobbin winder shaft. Install the second thread spool onto the extra spool pin. 1 Bobbin winder shaft 2 Extra spool pin 3 Thread spool Thread the right needle. 3 Thread the right needle in the same way that you threaded the left needle using the thread from the spool on the extra spool pin, but do not pass the thread through the guide above the needle before you pass it through the eye of the right needle. 3 2 2 1 ■ Twin needle threading You should thread each needle separately. Note ● You cannot use the needle threader to thread the twin needle. Instead, thread the twin needle by hand, from front to back. Using the needle threader may damage the machine (see page 24). Thread the upper thread for the right side 1 in the same way that the upper thread for the left side was threaded. 1 1 Thread guide • For details, refer to step 1 through 0 of "Upper threading" (page 20). Thread the left needle. 2 1 Left needle thread passes through the needle bar thread guide 2 Right needle thread passes in front of the needle bar thread guide 3 Needle bar thread guide Attach zigzag foot "J". 4 For details on changing the presser foot, refer to "Changing the presser foot" on page 8. CAUTION ● When using the twin needle, be sure to attach zigzag foot "J", otherwise the needle may break or the machine may be damaged. Turn on the machine. 5 CAUTION ● Do not turn on the machine while pressing down the foot controller. The machine may start unexpectedly and cause personal injury or damage to the machine. Select a stitch. 6 CAUTION ● After adjusting the stitch width, slowly turn the handwheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break. ● When using the twin needle, make sure the stitch width is not set above "2.5" since this may cause the needle to hit the needle plate and break. 30