Brother International SC9500 Users Manual - English - Page 23
For models equipped with the quick-set bobbin - case
View all Brother International SC9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Hold the end of the thread, push the bobbin e down with your finger, and then pass the Raise the needle to its highest position by turning a the handwheel toward you (counterclockwise) or thread through the slit, as shown. press (needle position button) (for models • If the thread is not correctly inserted through equipped with the needle position button), and the tension-adjusting spring of the bobbin raise the presser foot lever. case, it may cause incorrect thread tension 1 (page 41). Turn off the sewing machine. b Slide the button and open the cover. c 1 2 1 a Tension-adjusting spring Replace the bobbin cover. Put the left tab in f place (see arrow a), and then press lightly on the right side (see arrow b) until the cover clicks into place. a Cover b Slide button Insert the bobbin with your right hand so that the d end of the thread is on the left, and then, after pulling the thread firmly around the tab with your left hand as shown, lightly pull the thread to guide it through the slit. • Replace the cover so that the end of the thread comes out from the left side of the cover (as shown by the line in the diagram). ■ For models equipped with the quick-set bobbin Memo ● The direction for feeding the bobbin thread is indicated by marks on the needle plate cover. Be sure to thread the machine as indicated. a Tab CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. 21