Brother International XR3140 Operation Manual - Page 22
Winding the bobbin with the fast bobbin, winding system
View all Brother International XR3140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
KNOWING YOUR SEWING MACHINE Slide the sewing speed controller to the right l (to set the speed to fast). CAUTION ● Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle. a Sewing speed controller Press the foot controller or press m stop button) to start. (start/ When the bobbin seems full and begins n spinning slowly, take your foot off the foot controller or press (start/stop button). Cut the thread, slide the bobbin winder shaft o to the left and remove the bobbin. Slide the sewing speed controller back to its p original position. Memo ● When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction. ● The needle bar does not move when you slide the bobbin winding shaft to the right. 1 2 a Wound evenly b Wound poorly ■ Winding the bobbin with the fast bobbin winding system Place the bobbin on the bobbin winder shaft a so that the spring on the shaft fits into the notch in the bobbin. a Notch b Bobbin winder shaft spring Slide the bobbin winder shaft to the right. b Follow steps a through g of the procedure c in "Winding the bobbin" to pass the thread around the pre-tension disk (page 17). While holding the thread that wraps around the d pre-tension disk with your left hand, use your right hand to wind the free end of the thread clockwise around the bobbin five or six times. 20