Canon imagePROGRAF TM-200 TM-305 / TM-300 / TM-205 / TM-200 Setup Guide - Page 11

Perform Print Head Adjustment and Select the Connection Method When the screen for selecting the connection method appears, select the connection method to use. Note • If you are connecting the printer to the network using a fixed IP address, select Do not connect. Configure the settings from the touch screen of the printer after the printer has finished charging the ink for the first time and adjusting the print head. Wired LAN connection This is the method for connecting the printer to the network using a LAN cable. 1 Select Wired LAN connection. Check the message about the connection method and select Yes if there are no problems. 2 A message prompting you to connect the LAN cable appears. Wi-Fi connection This is the method for connecting the printer to the network without using a cable. 1 Select Wi-Fi connection. Check the message about the connection method and select Yes if there are no problems. 2 A message prompting you to set up Wi-Fi connection appears. 3 Use the LAN cable to connect the wired LAN connector on the side of the printer to the hub port. 3 If you are configuring from a computer -> Select Yes. If you are configuring from the printer -> Select No. USB connection This is the method for connecting the printer to a computer using a USB cable. Do not connect the USB cable yet. 1 Select USB connection. Check the message about the connection method and select Yes if there are no problems. 4 Select OK. The paper starts feeding, and then the printer automatically starts charging the ink for the first time and adjusting the print head. Charging the ink for the first time and adjusting the print head for the first time takes about 25 minutes. • Do not open the covers of the printer or turn the power off while the ink is charging for the first time and the print head is being adjusted. Important Note • If you selected Do not connect, the connection settings and software installation will need to be performed separately. Proceed to "Connecting to the Printer" on p.12. • Charging the system with ink fills the system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition. This may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. Starter ink tanks are for first-time installation. It is recommended that you purchase replacement ink tanks quickly. Wired LAN connection You can configure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connecting to the Printer" on p.12. Wi-Fi connection If you are configuring from a computer ->Y ou can configure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connecting to the Printer" on p.12. USB connection You can configure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connecting to the Printer" on p.12. If you are configuring from the printer ->C onfigure the Wi-Fi settings from the printer after the printer has finished charging the ink for the first time and adjusting the print head. Proceed to "Configure Wi-Fi Settings on the Printer" on p.13. 11