Canon imagePROGRAF TM-300 MFP L36ei series User Manual - Page 188

Cut to standard size Specifies standard size as the output page size when printing on roll paper. This setting item is displayed by tapping in the following order. (Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings • ON Cuts to standard size in accordance with the roll paper width. When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected automatically. Note • If ON is selected for Conserve paper and there is blank space above/below the image, the size will not be standard size. • When ON is selected for Print centered, printing will be in the center of the standard size. • If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is selected. No message is displayed. • For information about supported standard sizes, see Standard Size Table. • OFF (Initial setting) Cutting according to standard size is not performed. STANDARD CUT EXAMPLES • A3-size width roll paper A. Position of cut when OFF B. Position of cut when ON • A3-size width roll paper 188