Canon imagePROGRAF TM-300 MFP L36ei series User Manual - Page 635

Set the printer driver Automatic Cutting settings to No, and then print. Doing this prints only the left and right sides borderless. Cut the top and bottom borders with a cutting implement such as scissors after the printed materials are output and cut. Note • Selecting a higher Print Quality in the printer driver Advanced Settings may resolve the problem. Changing the Print Quality and Correcting Image Data (Windows) Changing the Print Quality and Correcting Image Data (macOS) Check 6 Check if the print head is in the right position Adjust the print head position. Automatic Adjustment to Straighten Lines and Colors Check 7 Color may be uneven if printing materials were stacked while drying To avoid uneven colors, we recommend drying each sheet separately. Check 8 Density may be uneven if using Glossy Paper or Coated Paper Set Print Quality to High, and then print. Check 9 Is the media type specified in the printer driver the same as the media type loaded in the printer? Load paper of the same type as you have specified in the printer driver. Loading Rolls in the Printer Loading Sheets in the Printer Follow the steps below to match the media type in the printer driver to the media type loaded in the printer. 1. To stop printing, press the Stop button. 2. Change the type of paper in the printer driver and try printing again. Check 10 Is Ink drying target area for Pause between scans in the touch screen menu set to Leading edge? If the Ink drying target area for Pause between scans is set to Leading edge, color may be uneven approximately 3.1 to 5.1 inches (80 to 130 mm) from the front edge of the paper. (The position depends on the Print Quality settings) In this case, set Ink drying target area for Pause between scans to Overall. However, note that printing will now take longer. Menu Structure 635