Casio CTK900 User Guide - Page 53

5. Play something on the keyboard. • You can also record Auto Accompaniment chords by selecting the applicable mode with the MODE button. • Optional pedal operation is also recorded. See "Track 1 Contents After Real-time Recording". 6. Press the START/STOP button to end recording when you are finish playing. • If you make a mistake while recording, you can stop the record operation and begin over again from step 1, or you can use the editing function (page E-58) to make corrections. • Using real-time recording to record to a track that already contains recorded data replaces the previous recording with the new one. Track 1 Contents After Real-time Recording In addition to keyboard notes and accompaniment chords, the following data is also recorded to Track 1 during real-time recording. This data is applied whenever Track 1 is played back. • Tone number • Rhythm number • INTRO/ENDING 1 button, INTRO/ENDING 2 button, VARIATION/FILL-IN 1 button, VARIATION/FILL-IN 2 button, SYNCHRO/FILL-IN NEXT button operations • Pedal operations (option) The following data is recorded in the header whenever you start a recording of a track. • Mixer settings of other tracks • Effect type • Accompaniment volume • Reverb Level • Chorus Level • DSP Hold On/Off • Mixer Hold On/Off Song Memory Function Mixer Mode Settings Channel 1 Mixer parameters (page E-36) are automatically recorded to Track 1. You can use the Mixer to change each of the parameters. Memory Capacity The keyboard has memory for approximately 10,000 notes. • The measure number and note number flash on the display whenever remaining memory is less than 100 notes. • Recording automatically stops (and auto-accompaniment and rhythm stops playing if they are being used) whenever memory becomes full. • Initially, nothing is stored in song memory. Memory Data Storage • Whenever you make a new recording, anything previously stored in memory is replaced. • Turning off the keyboard while a record operation is in progress causes the contents of the track your are currently recording to be lost. • Remember that you can dump memory contents to another MIDI device using the procedure described under "Using the Music Data Management Software (on the Bundled CD-ROM)" on page E-76. Track 1 Real-time Recording Variations The following describes a number of different variations you can use when recording to Track 1 using real-time recording. All of these variations are based upon the procedure described under "To record with real-time recording" on page E-50. J To start recording with synchro start In place of step 4, press the SYNCHRO/FILL-IN NEXT button. Auto-accompaniment and recording will both start when you play a chord on the accompaniment keyboard. J To record using an intro, ending, or fill-in During recording, the INTRO/ENDING 1/2, SYNCHRO/ FILL-IN NEXT, and VARIATION/FILL-IN 1/2 buttons (pages E-32 to E-33) can all be used as they normally are. J To synchro start Auto Accompaniment with an intro pattern In place of step 4, press the SYNCHRO/FILL-IN NEXT button and then INTRO/ENDING 1 or INTRO/ENDING 2 button. Auto-accompaniment will start with the intro pattern when you play a chord on the accompaniment keyboard. 707A-E-053A E-51