Cisco AIR-AP1230B-E-K9 Hardware Installation Guide - Page 72
Mounting Bracket Holes, Access Point Mounting Bracket, Step 1
View all Cisco AIR-AP1230B-E-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Mounting Above a Suspended Ceiling Chapter 6 Mounting Instructions The bracket mounting clip requires the use of an access point mounting bracket (700-13520-03) with two extra holes (see Figure 6-4). Figure 6-4 Mounting Bracket Holes 1 1 95748 1 Extra holes Follow these steps to mount the access point above a suspended ceiling. Step 1 Step 2 Insert the bracket mounting clip's tab into the large hole on the access point mounting bracket. Place the clip over the T-bar box hanger and secure it to the access point mounting bracket (see Figure 6-5) with the 1/4-20 fastener (supplied with the T-bar hanger). Figure 6-5 Access Point Mounting Bracket 95739 Note The illustration shows the access point mounting bracket mounted perpendicular to the T-bar box hanger. You can also mount the bracket parallel to the T-bar box hanger. Step 3 Step 4 Determine the location in the ceiling where you will mount the access point and remove an adjacent ceiling tile. Orient the access point 2-GHz antennas so that they are pointing down when mounted on the T-bar Box hanger. Orient the 5-GHz antenna for patch or omnidirectional operation as desired. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 6-6 OL-4310-05