Cisco SLM2008T-NA User Guide - Page 23
Advanced Configuration - snmp
View all Cisco SLM2008T-NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 5 Advanced Configuration Chapter 5: Advanced Configuration Overview This chapter describes the features included in the Webbased Utility. All of the features shown in this chapter, unless specifically identified, are included in the all of Fast Ethernet switches. Additional features for specific switches are noted. Accessing the Web-based Utility NOTE: The web-based utility is optimized for viewing with a screen resolution of 1024 x 768. Internet Explorer version 5.5 or above is recommended. Open your web browser and enter 192.168.1.254 into the Address field. Press the Enter key and the login screen will appear. NOTE: The default IP address of the device is 192.168.1.254. If you have modified this address, enter the correct IP address. The device should be on the same subnet as the management station used to configure the device. . The first time you open the web-based utility, enter admin in the User Name field, and leave the Password field blank. Click the OK button. You can set a password later from the System Password screen. The first screen that appears is the Setup Summary screen. Twelve main tabs are accessible from the web-based utility: Setup, Port Management, VLAN Management, Statistics, ACL, Security, QoS (Quality of Service), Spanning Tree, Multicast, SNMP, Admin, and Logout. Click one of the main tabs to view additional tabs. Login Screen 8-Port 10/100/1000 Gigabit Switch with Webview NOTE: The LEDs displayed in the web-based utility are not the same as the LEDs on the front panel of the Switch. The front panel LEDs display different status information, which is described in Chapter 2: Overview. The LEDs on the Setup Summary screen display status information about their corresponding ports. A green LED indicates a connection, while a grey LED indicates no connection. An orange LED indicates the port has been closed down by the administrator. When you click a port's LED, the statistics for that port are displayed. NOTE: After configuring values using the web‑based utility, you may be required to refresh the page to see the updated configuration. Setup > Summary The Summary screen provides device and system information about the Switch. Setup > Summary Device Information System Name Displays the name for the Switch, if one has been entered on the Setup > Network Settings tab. IP Address The IP address of the Switch is displayed here (configurable from Setup > Network Settings tab). Subnet Mask The Subnet Mask of the Switch is displayed here (configurable from Setup > Network Settings tab). DNS Servers The DNS Servers are displayed here (configurable from Setup > Network Settings tab). Default Gateway The Default Gateway is displayed here (configurable from Setup > Network Settings tab). 17